Done with oil deliveries
Oil and Gas Heating Replacement in Arlington
Send the clanking cellar unit into retirement and let one heat pump warm and cool the place, with the old unit hauled out or kept as backup on proper controls.
Leaving the Old Burner Behind, Step by Step
Lots of older Arlington homes still depend on an oil boiler that has outlasted several owners, or a gas furnace wheezing through each heating season. Replacing it with a cold-climate heat pump brings one machine for warmth and cooling, an end to fuel deliveries where oil or propane is involved, and a house ready for an electric grid that keeps getting cleaner. The important choices come first. Should the heat pump carry the entire house, or claim certain zones while the existing equipment handles the rest? If the old unit is going, it gets removed or disconnected. If it stays on as a backstop, Mass Save calls for integrated controls that let the heat pump lead and bring the boiler or furnace in only during deep cold. Every choice shapes which incentive applies and how the HEAT Loan can be used, so we set the options out in writing next to each other. Next, the crew installs the heat pump, handles the old equipment as agreed, tests the whole arrangement and shows you how the controls behave. If an oil tank is being retired, we explain beforehand how its removal gets arranged.
What Goes Into a Replacement
Most replacement projects share these elements.
All at once or zone by zone
A clear decision between converting everything now or starting with certain areas.
Sizing from heat loss
Room-by-room measurements so the heat pump can handle its portion of the house in January.
Removing the old unit
Hauling out or disconnecting the boiler or furnace when the heat pump fully takes over.
Integrated backup controls
Wiring that limits a remaining boiler to the coldest stretches.
Tank retirement plan
How the oil tank gets emptied and taken away, explained in advance.
Summer cooling included
The same system cools the house, often sending window units to the curb.
Program-ready setup
An arrangement that meets program rules so eligible incentives and HEAT Loan financing can apply.
Commissioning tour
Testing plus a clear explanation of how the heat pump and any backup divide the work.
Carrying Out the Switch
Inspect what is there
We study the existing burner, the pipes and radiators or ductwork, the fuel, the panel and the building, and discuss whether you want backup heat to remain.
Pick a route
The proposal weighs full replacement against a zoned approach where sensible, listing equipment, price, incentive estimate and loan amount for the route you favor.
Install and decommission
The heat pump is installed, the old unit removed, disconnected or tied to integrated controls, and the house tested before we hand it back.
Why Owners Let Us Handle the Changeover
Choices compared openly
Full and zoned conversions weighed plainly, with their impact on incentives spelled out.
Backup wired correctly
When the old unit stays, it is set up so the heat pump leads and the backup waits its turn.
Every loose end tied
Old equipment, tank plans and program forms are all settled before we leave.
- Full or zoned routes
- Old unit dealt with
- Backup controls configured
- Program rules respected
Sick of Babysitting a Tired Boiler?
Let us know what fuel you burn and how old the equipment is. We will explain how a heat pump could take over and what the programs might cover.